How To Use Glass Smoking Shisha Hoohak

First step: How to use a hookah, the first step is to fill the hookah with water. Do notfill the water, as it will affect the following steps. The water level should reach about 1-1 1/2 inches above the bottom of the tube. Submerge the tube in the water. Place the long stainless steel tube in the glass or crystal base. Ensure it is tightly sealed and airtight There should be a rubber plug between the glass/crystal base and the metal parts to ensure the airtightness of the hookah.

Second step: the clay bowl and place it on the metal middle part. There should be a plastic gasket between the metal middle part and the clay bowl. Insert the hose the metal middle part and connect it securely with the plastic gasket to ensure airtightness. This is the second step in using a hookah.

Third: To use the hookah, the third step is to test your setup by placing your hand over the hookah’s bowl and sucking through the hose to check airtightness. If everything is normal, you should feel your hand being pulled and see bubbles in the water. If these two things do not happen, is likely that air is leaking from somewhere.

Fourth step: Ensure that the edge of the clay bowl is level, then add some soaked tobacco to the bowl. sure that the tobacco is spread out and not restricting airflow. Do not let the tobacco level reach the top of the bowl or overflow. Cut out a round or piece of foil about twice the diameter of the bowl and place it on top of the bowl to ensure it is flat. Then take a toothpick or sharp object and small holes along the top. This is the fourth step in using a hookah.

Fifth step: Make sure you have the charcoal in the hookah, it up, and start smoking. You should taste the tobacco in your mouth, nose, and throat.